Excavation services in Fort Collins, Colorado by Stormheart Construction

Construction services in Fort Collins, CO? Cable, pipe, and service plans should be used to ensure that underground services are known so they can be marked on the ground or, ideally, the area avoided entirely. Around the areas where there are underground services, mechanical equipment should be avoided and instead use spades and/or shovels. Picks and forks should be avoided as they are more likely to pierce cables and pipes. Flooding can be avoided by ensuring that there is appropriate pumping equipment so that any water that seeps into the excavation can be easily pumped out to a safe area.

There’s a certain amount of paranoia among the public when it comes to dealing with builders. The fact is, most builders try to do a decent job, often despite late payment and awkward clients giving them a lot of grief. Individual tradespeople can actually be a mine of valuable experience. Of course, sometimes there’s an ulterior motive to drum up business. But it’s often the case that the person tasked with doing the job will know a better, less expensive or simpler solution in a specific area than designers focused on the bigger picture. Trades also tend to have a useful knowledge of materials and local suppliers, potentially helping you save time and money. So don’t automatically disregard advice from the person doing the job.

Trenches 5 feet to 19 feet: OSHA explains that any trench other than those made of stable rock exceeding 5 feet in depth must have a protective system in place. The protective system must be implemented by a competent person. This can be any worker who is qualified and capable of identifying rock and soil composition and hazardous excavating conditions in addition to possessing the knowledge and authority to take corrective action. Discover additional information at Excavation services Fort Collins.

Retaining wall drainage is an incredibly important part of building a stone wall. Once a few rows have been stacked, backfill the wall with rock so it matches the grade height in front of the wall, and then lay down perforated drain tile on top of the rock. Install drain tee fittings and a drain grate every 25 feet to 50 feet, depending on how much rainwater is expected to run down to the wall. Cut one block down to accommodate the drain grate. Screw the drain tile parts together so they won’t come apart when they get covered with more rock. Also, drain the tile to daylight at the ends of the walls whenever possible.DO start with a good foundation. Your retaining wall will only be as strong its support system. For a stacked-block retaining wall that’s no higher than four feet, a trench filled with three inches of crushed rock will help keep the wall from shifting and settling. The exact depth of the trench depends on the proposed height of the wall, but follow this rule of thumb: Dig a trench to be an eighth of the wall plus three inches. For example, if you want the finished height of your retaining wall to be three feet (36 inches) tall, you’d need to dig the trench eight inches deep to accommodate three inches of crushed rock and about five inches (or an eighth of the visible retaining wall) to start the wall below grade.

NFC can either be mixed on-site for smaller areas or purchased from a reputable concrete supplier and trucked in for larger commercial applications. NFC is mixed at a 6:1 ratio by volume of 20mm max size clean aggregate and cement. Water content should be such that the cement slurry evenly coats the aggregate and retains a wet/glossy appearance without excess slurry running off, this is typically around 40 litres per 100kg of cement. With the use of NFC, we are able to build Block Retaining Walls in areas and situations where normal construction methods would not work. Some of these situations are: In areas where excavation behind the wall is limited either due to being on a boundary or close to other structures or footings. Discover extra information on this website.